Authors
Joana Cordeiro, Isabel Vasconcelos, Joana Marques, Margarida Franco, Nuno Alves, António Mata, Josette Camilleri, António Ginjeira
Published in
Dental materials : official publication of the Academy of Dental Materials. Nov 07, 2026. Epub Nov 07, 2026.
Abstract
Cell culture experiments are difficult to reproduce due to variability in methods and in the materials used. To this end, a 3D printed holder device for cell culture assays is proposed. Four base materials were evaluated: two PolyJet photopolymer resins, VeroClear™ and MED610™ (Stratasys, USA), and two FFF/FDM thermoplastic filaments, Facilan™ C8 (3D4Makers, The Netherlands) and polylactic acid (PLA) (ROSA Filaments, Poland). Cytotoxicity was assessed using immortalized human gingival fibroblasts (hTERT) in direct contact with the printed holders (n = 10), with viability measured at days 1, 3, and 7 using a resazurin-based assay. Statistical analysis was performed using one-way ANOVA or Kruskal-Wallis tests with post-hoc comparisons (p < 0.05). Results are expressed as mean ± SD. At day 7, the PLA group exhibited significantly higher cell viability (71.1 ± 11.0%) than all other groups (p < 0.001) and was the only material remaining above the ISO 10993-5 cytotoxicity threshold; therefore, it was selected for exploratory characterization. PLA optical profilometry analysis showed arithmetic roughness (Ra) of 1.37 ± 0.12 μm. During 21 days in culture medium, PLA holders showed stable pH values comparable to controls, negligible mass variation (<0.55%), no relevant FTIR spectral changes, and only minor SEM surface alterations. These preliminary findings support PLA as a promising candidate for short-term holder fabrication in direct-contact cell culture assays.
PMID:
42998932
Bibliographic data and abstract were imported from PubMed on 08 Nov 2026.
Read full publication at:
Please sign in
to see all details.
Advertisement
Stats
- Recommendations n/a n/a positive of 0 vote(s)
- Views 7
- Comments 0